Cylindrical Machines
These four models are built specifically to grind cylindrical parts for instance bearings, curvic couplings, honeycomb rings, stator cases, gears, sprockets, shafts, and vane rings. These machines have the ability to grind ID, OD, faces, tapers and curvic features while doing this in a vertical configuration not needing a steady rest or tailstock, thus enhancing accuracy and repeatability. Campbell Grinder models are based on size and machine design.
 |
Model - 700 Campbell Grinder 700 is an elevating rail machine that has a table diameter from 48 inches to 80 inches. This machines vertical travel starts at 48 inches and is increased by 12 inch increments up to 96 inches. This model 700 is well suited for tall parts with smaller diameters (i.e. shafts, landing gear, cylinders, etc.).
For More Information on the 700 Machine |
|---|---|
 |
Model - 750 The model 750 is a smaller version to the 700 machine and has a table diameter from 12 inches to 36 inches. The 750 is an elevating rail machine. This machine is available with up to 36” of vertical travel. This machine is well suited for parts up to 30 inches high.
For More Information on the 750 Machine |
 |
Model - 1000 Campbell Grinder 1000 model is a traveling column style machine that has a table diameter from 42 inches up to 84 inches. This model 1000 is well suited for tall parts with smaller diameters (i.e. shafts, large gears, steel mill sleeve, etc.).
For More Information on the 1000 Machine |
 |
Model - 3000 The model 3000 is a bridge style grinding machine. It can be configured with up to 9 axis and often with duel spindles and dressers. This machine was designed for large low profile parts. (i.e. bearings, optics, large gears, turbine engine panels, etc.).
For More Information on the 3000 Machine |
